Site Navigation

Forum Categories
- Announcements
- General Discussion
- New Members
- Forum comments
- Fishing Reports
- Fishing Videos
- Fishing Discussion
- Fish Stories
- Trading Post
- Salt Water
- Fresh Water
- Recipes
- Charters and Guides
- Boats and Motors
- Electronics
- Rich Lindgren
- Kayak Fishing
- Hunting and Camping
- Maglite Flashlights
- Hardware/Software Help
- Camping Gear
- Hunting Gear
- Maglite Sales
- Link Directory
- AIG Top Sites
- Fishing Charters
- Free Tackle
- Charter Listings
- Saltwater Tides





All in General Outdoors Top Sites

Freshwater Fish ID
Saltwater Fish ID


Harden Bronze Bushing,flange bronze bushing manufacturer

Buy, sell or trade fishing equipment, boats, motors, etc.

Harden Bronze Bushing,flange bronze bushing manufacturer

Postby slidebearing » Mon Mar 28, 2016 10:54 pm

Harden Bronze Bushing method engine disintegration of the engine disintegration exposed bearings and bearing assemblies, to separate the FR soft strip bushing inner ring with a small hole refueling beak grease gun, stainless steel powder sintered oil bushing overflow when rotating bearing until the bearing ring overflow can have butter. After the above two methods treated within six months bearings can no longer refuel.
Not the disintegration of the engine oiling method first opens the sintered gear, powder sintered parts, release bearing wear concept check, if confirmed no damage or wear bearing no overrun, remove the clutch pedal, adjusting the Powder sintered parts-PM wrench, the separation bearing and housing back to the last position, the bearing bore butter filling with beak grease gun, until the bearing oil spill, then rotate a little bit bearings, oiling again, repeat the above work, have a little butter until around spherical bronze sintered bearing,spherical plain bearings overflow, then make bearing rotation, observe oil, bearing rotation if they feel there is resistance, proof has been filled with grease in the bearing. Then clear separation of bearing the entire spill a small amount of butter, to remove the pin and reassemble the spherical iron sintered bearing and so on.
Posts: 12
Joined: Mon Mar 28, 2016 2:24 am

Return to Fishermen's Trading Post

Who is online

Users browsing this forum: No registered users and 1 guest